Freud 32-504: flush, 1/8",1/4",5/16",3/8",7/16",1/2" Depth Rabbeting Bit with Bearings

Used this to cut groove for 1/4" plywood backing on back of bookshelves. Worked great.

Freud has good products always try to buy them when i can have not been disappointed yet

Great patterning bit with the multiple bearings provided. Does the job well!

I built a tool chest for under the woodworking bench and decided to inlet the back of the carcass with a rabbit to lay the back into. Since I hade already assembled the box, I needed this rabbeting bit. The bit worked great, cut like butter. The bearings themselves have an aluminum outer diameter that makes the bearing outer dimension. Yes, they look very cheap because they are, but they will not be running 24-7 for five years either, should probably be fine for the application.The cutting bit is huge and heavy (see picture) so run your router at a lower RPM. No storage for the bearings, other than the paper box; I deducted one star. Freud could have incorporated the bearings into that pretty box- now I will be doing that, increasing the price I have in the cutter set. I plan on embedding/ attaching a few rare-earth magnets to the base to hold the bearings. Other than Bearings in a thin paper box, the set is good and performed with flying colors on 3/4" birch plywood.

Very versatile set. Makes it easier to step through progressively deeper cuts on curved edges where can’t use fence (oval picture frame rabbits), particularly at joints.

I got this set so that I could cut rabbets for inset cabinet door fronts. I tried a few different bearings on some test pieces and found the perfect size for my use. The bit cut through like butter and it was so easy to swap out the bearings.There’s not a great system for keeping all of the small parts, so make sure you have something in mind for that part. Still, it’s a set that I will use over and over again.

Used to cut a groove in Corian. Performed very well.

This little cutter worked great.The bearings were easy to change.Left a great finish around the edge of the box.

Excellent quality bit. Not just for rabbets. I used it to cut a 1/2" x 1/4" deep dado 1/4" in from the work piece edge in oak. Plowed out the dado neat, quick and easy in one pass. Couldn't ask for anything better.

Freud continues to make high quality bits and blades in Italy. Let's hope this never changes. I have used their products for many years and have e never been disappointed.. This rabbeting bit cuts well and leaves an excellent finish. An additional bonus is all the extra bearings which are used to reduce/increase the rabbel size but can also be used on other bits with the same I.D.

Fresa de buena calidad un poco cara pero espero que dure mucho tiempo

Arrived quickly, excellent quality, worked really well

Very good quality. Cuts great.