Kreg Adaptive Cutting System Master Kit

First thing I was surprised when it arrived a week ahead of its scheduled delivery date, before Christmas not after. It shipped in 3 different boxes and separate labels so that caused a little confusion for me, but all were delivered the same day just by different persons. It takes a little time to setup, and I would strongly recommend watching the Kreg table setup video before starting because it clears up some finer points that are a little confusing in the instruction manual. Setup took me 3 hours to do all the steps, but then it cut perfectly afterward. Would highly recommend it if you have been thinking about it and were needing a track say option in your shop.

I needed a solution for more accurate cuts as my table saw is a portable contractor's saw. It does the job, but is far from accurate especially when doing long rip cuts. While the length of rip cuts it can make is limited, I haven't needed to make any longer than the table will allow and if necessary I can buy a track extension and remove the track from the table for such cuts. The instructions could be a little clearer, but it want' difficult to set up and I have been very pleased with it during the last couple of products I have completed. The only two things you have to remember is to always adjust your cutting depth to make sure you cut completely through the material, but not through the table, and you need to keep the blade track in the table clean or the debris in it will push the saw's riving knife up making your cuts slightly inaccurate and preventing the saw from cutting completely through the material. I have not regretted buying it and Kreg's videos about it are spot on, it functions just like they say it will.1 year update. I still love the saw but have had 2 issues both of which Kreg took care of. When I first received the project table, two of the parts were improperly machined. I reached out to Craig and they immediately sent me a replacement no questions asked. About six months ago I began having issues with the Saul cutting off in the middle of a cut. I cleaned out the salt and put it away thinking maybe it just got back with sawdust and I had overheated it but the next time I went to use it it’s still cut off about 6 inches into my first cut. I gave it a moment And it completed the cup without issue. Being concerned that there may be a problem with the saw I reached out to Kreg, once again they were super friendly and immediately agreed that there was an issue with the saw and they would send me a replacement out immediately. Service techs are very friendly and incredibly knowledgeable about the products. I don’t think you could ask for better service.