30ft PET Expandable Sleeving Wire Cable Sleeve (1/2", Red&Black)

Looks great,easy to install..I used black heat shrink to seal the ends....keeps them from fraying.Covered throttle cable,light wiring,fuel line,etc.

Okay so usually I'm not a review guy but I had to come here to address some of the bad reviews this wire loom received. Okay first things first, Yes it's not a split loom! You should be able to tell that from the pictures, split loom has a distinct fold over style you can easily see in the pictures and descriptions. Second, the fraying. These are obviously people that have never used loom before. It's braided. Meaning it will come unbraided anytime you cut the heat seal off the edges. Want to prevent that? Than either hit the tips with a lighter or butane torch and seal the ends, or properly cut them with a hot knife like they are meant to be used. Third the quality and melting of the product before heat shrink. So far I've tried 4 diff Amazon looms, eBay looms, stuff from Walmart, etc. If I seen it cheap enough I tried it....and for the price this stuff is exceptional. I will personally source this for my installs over anything else. Of course the loom is melting, its loom! Lol. Protect your wire ends properly with electrical tape or even a piece of aluminum foil before you slide the heat shrink on, then the foil before going at them with a heat gun or whatever else then the foil or tape will rip easily away. This way will also prevent unwanted unravelling until you get the ends heated.(Pic#3)

High quality cable wrap. Be careful when heat shrinking not to get too close as it will melt if you get too much heat on it. I found after cutting with sharp scissors it’s best to gently burn the end with a lighter so it doesn’t fray while inserting the wires.

This stuff works great, but there is a trick to it. It expands by compressing it and shrinks when you stretch it. You can't pull cable through it, you have to push, a little at a time, by holding the ends of the cable through the sleeve and pushing the empty sleeve over the cable. Once you find the trick it's easy. Trying to pull it through is impossible. It's like one of those Chinese finger puzzles.

Sleeving worked well on my 12 gauge dual copper speaker wire. Easy to install and looks great when finished.

Easy to use, and offers great looking cables for DIYers! Purchased a 30' length for speaker cables I built myself at 12' each. The best part is, the sleeve DID NOT FRAY after being cut!

They give character and style to my RC cars allowing me to personalize the look inside the vehicle.

I admit this is probably a skill issue on my end but I can't get this to slide over a USB-C connector on a laptop power adapter. Diameter is too small. I got this thinking it would be a quick way to pet proof the cord since they bit through it and I just patched it up. Maybe it's just me but I can't see how this expands over the width of the connector since I can't even stretch it go over the USB-C end of it. I would be OK with this if it was relatively simple with a just a little effort as I thought it would be but if I need to learn a special technique, cut my hands up to figure it out, or if it requires extra equipment then it's not worth the time and effort.