Auto Dynasty Rain Guards Tape-On Compatible with 2000-2006 Sentra B15 4DR 4Pcs Window Vent Visor Deflector

Very good as expected, looks nice on the car

Pro's: I can sit in the rain with all 4 windows cracked. I can drive with the window half open with no worries. I can leave the windows open on a hot day and keep my car cool. Con's: Some of the pre-installed sticky tape wasnt that sticky ( still hold on just not everywhere). The rear window cover's are a little short and it shows if you cracking those windows. Worth it: Oh hell yes.

Holding up nicely in cold wet weather in New Hampshire..I had to put them on My truck a 2012 Nissan Pathfinder V8 325 . A very large truck the Windows are large and these fit great..The Day i put them on was around 10 degrees F out ..I wiped down the outside of the doors and placed on the pathfinder without any problems at all...They are nice to sheld out the rain an show without have weather come inside only air...very nice..Even at a high rate of highway speed ( got a $500 ticket for traveling over 100 mph ) they still where on the Truck...Even the Cop had said they where nice looking as he handed me my $ 515 ticket for speeding 109 mph....:(

These do not fit an R51 Nissan Pathfinder. There is a curve or raised area towards the front of the guard. It needs to be completely flat to fit a NPF. The curve or raised area leaves about a 3/4 inch gap not allowing it to adhere to the door. The first time I'd take it out, I am confident they'll come off.

These are very nice and easy to install, they look great on my '15 Xterra. Install is a piece of cake if you follow some common sense steps. Clean the mounting area with rubbing alcohol and let it dry. It's best to put them out in the sun for a bit to warm up the tape, it's good to do this on a warm day or use a hair dryer to heat them up if it's cool out. Obviously if you try to mount them on a cool, damp day or if it's raining, your results are going to suck. Do a dry run and see exactly how you want them mounted and mark each side of the door with tape. Don't peel the whole cover off the guards and try to mount them, if you get things misaligned and stuck, you're gonna have a bad time! Peel back the last inch or so of the tape cover on each end and put one side in place. Line up the other side with the tape and slowly start peeling back the covering while pressing the guards down as you go. Work your way to the other end and that's basically it. Press them in real well a couple more times to make sure they're thoroughly in place and you're done. I've seen complaints about the tape, but I can't comment on that at the moment, time will tell. I think as long as you prepare right you'll be fine. They seem very nice for the price.

With the very hot weather, I wanted something that fit our Nissan Cube... these fit perfectly and offer some extra shade... most importantly, they allow me to "crack" the windows which allows the hot air to NOT build up... that alone, is worth the money...

I have a 2018 Nissan Versa. They don’t fit PERFECTLY! They also came slightly bent! They will apply easily due to the adhesive BUT since the guards aren’t the exact same shape as the car windows they are a little harder to adhere properly. I had to use some double sided adhesive tape. They got the job done but i think i will be returning them for ones that’s fit better adhesive and visually.

Love them

Great!

remove and replace with a quality tape, I use 3M. Very flimsy and bad fitment quality around some edges, also definately not darked out enough to be Black.

Thanks guys. Arrived earlier than expected and fits great,looks good. Careful when you install them .... edges are VERY SHARP! Took the pad right off my finger! Other than that, fantastic! Thanks again Steve