Diode LED Tape Light Terminal Block Connector Screw Down 8mm Tape-to-Wire White Pack of 25 Individually Bagged

I've been installing tape light for several years now and until I found these I was using the snap connectors. these are far superior to any of the alternative non-screw set connectors. You can over-tighten them and the screws will cause the tape to twist under the strain, but still they seem to make very clean, solid and reliable connections. That being said, I've only used these on about a half dozen jobs now and have not had them in service for prolonged periods. If I have an update to this information, I'll probably post it.Update: I've been using these for 2 and a half years now and still no problems with them. You can overtighten and crack the plastic, but if you watch what you are doing you can see the plastic start to distort, which means you are tightening tooooo much.

They don’t fit inside track is my biggest complaint. Other than that they work. Nothing beats soldering your connections if you can.