G109 75Grams Thermal Glue, Thermal Conductive Plaster, Silicone Viscous Adhesive Compound for LED GPU Chipset Printer MOSFET Heatsink Cooling Sealing

One distinction to note is that this is glue, as in you use it to permanently fix the heatsink onto the thermal load, don't put it in your gaming PC as thermal paste- you're gonna have a bad time. When used as intended however, it works great.

So I was worried about the poor thermal conductivity vs. older discontinued solutions like Arctic Silver. Well, the good news is you can mix this 50/50 with a good thermal paste like Thermal Grizzly and it will still make a permanent bond. I didn't sit there cranking on them to test my luck, but the final adhesion was rock solid. Supposedly mixing with thermal compound is also a solution for people who want good "permanent" adhesion, but is still breakable when removing the heatsinks so that you're not ripping chips off the board. For both that and the much better thermal conductivity, I would highly recommend diluting 50/50 with a good thermal paste as I did. It will definitely hold as good as you could possibly need.

It's hard to have a sense of scale on amazon, and I previously bought much smaller tubes that seem to run out instantly. This thing is a champ and has SO much more usable paste in it. It lasts wayyy longer, and it's a much higher quality too.

Recommend