Mr. Surfacer 1000 Spray

Even coat, sands easily, dries in a reasonable amount of time. Used this to finish some laser-sintered 3D prints. Leaves a really smooth finish with sanding. A little expensive for the size of the can, but suited my needs well so that's a non-issue for me.

Works well, leaves detail, and dries rather fast. The pity is, it is a small container.

If you model AFV's as I do, this, though a bit expensive, is the best primer you can buy, period.

This grit is good for using as a gap filler. It will leave the surface feeling rough like sandpaper though and will fill in panel lines so you may have to rescribe panel lines. Be careful not to spray too much or you will loose details. Personally I prefer the higher grit Mr. Surfacer 1200 or 1500. It dries quickly and is wet sandable. Use this if you are filling in seams or other gaps or imperfections or for 3D prints.

Compared to Tamiya, it takes longer and stronger fumes.

なかなか良い

プラスチック部品のプライマーとして使用しました。とても良かったです。

ムラが少なく均一に吹けました

プラカメラの作成、塗装で使用しましたが、サイズ的に1缶でちょうど良い感じでした。しっかりとやすりをかけないと剥がれやすいのでその点だけ注意。