COMINGFIT 2026 Upgraded Bicycle Cargo Rack, 180lbs Heavy Duty Bike Rear Rack, 4-Leg Double Strength, 2.0mm Thickened Universal for MTB Road City Kids Fat Tire Bike (3.5"), with Anti-Rub Guards

I am usually good at putting things together, but this was utter hell, I would pay someone to install it again. It's not hard, it's very straight forward, but it's tedious as heck, you got to hold the little wrench on one side, and screw screw screw with the other thin allan wrench, dropping it about 100 times, and keeping the bolt in the other wrench, it is a pain. Why on earth do they make things so difficult with the nuts and bolts, the design should be better CHINA. It seems fairly strong, but I would not be placing anything over 50lbs on it, would be asking for a problem. if it snaps I will tape it, this is my first and last rack on this bike. I've seen similar looking racks direct from china for 20.00, I am not sure how they compare, but this one seems a bit expensive in my opinion, but does seem stronger just judging by the listing and what it said, that's why I got it.

First, I will list some shortcomings. 1. It does not include instructions, which is well documented. Some people are complaining about this. However, instructions are available online and I was able to install it easily without them. It is pretty intuitive. 2. Screws included are good quality but they are way too long. If you do not have much clearance, they might touch the spokes. 3. Not much clearance between the seat and the rack unless you move the rack out of the supporting beam. This is a design flaw. The supporting beam should be a little bit longer. Items to watch for: 1. Make sure you do not have any brake or shifter cabling where the supportive legs are attaching. This is by design, if you are not careful, it is your fault. Do not blame the product. 2. If your seat is pretty high above the wheels, and you attach it to your seat post, it might look pretty ridiculous. Mine is like this. But again, that is by design. If you do not have to use the seat post and have attachment points in the body of your bicycle, you may order a different type. 3. Those who have carbon fiber frames should be very careful not to overtighten the clamps. Use a torque wrench if possible. Cf frame owners should also limit their weight expectations considerably since their frame will not be able to carry a heavy load. Pros: 1. I had more than a dozen racks and installed many more during my lifetime. This product is sturdy and built heavy duty. If you do not move out the rack to the back beyond the supporting beam, it would easily carry 180 lbs if not more. However, if you move the rack out, then since there is no support below it, the amount of weight it can carry will drop. This is basic physics. Some reviewers are complaining about the rack being bent while they pulled it out all the way. What can I say, of course, it will! On the other hand, all other racks on the market would bend at that point too. I believe this is the most Heavy-duty rack you can buy in the market. If this fits your bicycle, I would recommend it to everyone.

It didn't come with any instruction at all, not that it would've helped much. It was very difficult for me to install by myself. Once you attach it to your bike, it's very sturdy and works great though. It even works for my bike with no rack mounting holes. I'm short and I was worried it would put the seat too high up. With a little adjusting, I was able to get the seat at a comfortable height without the rack hitting my rear wheel which was a huge problem with my last one.

Wow what a great cargo rack. The design is excellent. It's such a great fit, too. The angle at which it sits is adjustable. It has a solid 70 pound carry capacity. I think it's very versatile, fitting most bikes. What a great buy!

Update: I downgraded my rating from 4 to 3 stars, because I found my pannier is unable to hook on smoothly to this rack. The bolt attaching the rack and its support leg sticks out far enough to prevent the pannier from being able to attach two hooks securely to the rack tube. In order to get a smooth section of tubing to clip my pannier bag to, I had to add 4 p-clamps and a 8" long 1/4" stainless steel tube. If your bike has frame holes to mount a welded rack, definitely go for that option if you plan to use pannier bags. This rack may be the only option if you have a bike without any frame holes, however. Overall, this is a purchase I am happy with, but I see that Amazon now carries another rack from COMINGFIT with 310lbs capacity and more parts to help prevent panniers from catching in the wheel spokes (and it is currently cheaper than this rack). I recommend buying that rack instead! But I willl say this rack is very sturdy, which I was not sure would be possible on my single speed bike which has no holes to mount conventional racks. I think other people having issues with the rack bending is probably because they put the clamp near the tapered end of their seat stay--definitely give your rack a good test before actual use, and move the clamps more toward the center of your seat stay if you must, to get a better grip. To the manufacturers, please replace your long bolts with shorter ones. The long bolts take forever to screw on, and they are dangerously close to the wheel spokes. I ended up swapping some of this rack's long bolts and short bolts, to avoid bolts tpotentially ouching the wheel spokes. Also, the clamp around the seat tube is too wide, and rubs against my right thigh when biking. I could see this irritation rubbing a hole thru my pants over long term use. Please consider reorienting the clamp so that the hinge is toward the front of the bike and the closure is toward the back of the bike, which would let the overall clamp remain slim enough to not interfere with the cyclist's legs

It is a bit cumbersome to install because you need to bolt each joint which just takes a while but it is simple to do. That makes it very strong because it has 4 points of contact with the frame and 1 point of contact with the seat post. Also since the joints are bolted it has many degrees of freedom and you could probably attach this to most any standard bike frame.

I got this rack to carry my school books. I go to university in the US. It is very good for carrying many books. It is also well for carrying small amounts of groceries. It is very strong and sturdy. It is easy to assembly as well. It is so strong that I decided to try and carry a kayak on it. I tied the kayak across the rack. I had to use many strings to keep it mounted. I started to ride my bike down the sidewalk to the lake near campus. I knocked over many people. From now on I will only use this rack to carry books and groceries. It is very good for that. I have hurt no people while carrying books or groceries.

This took like 2 hours to install, for me who is handy and has all the necessary tools. My wife used it on her bike to carry our 22month old in a bike seat. They used it probably 10 times this summer, and today it broke and the toddler fell off the bike because of it. Incredibly unsafe, luckily the helmet and bike seat kept the baby safe. You can see from the picture how the thin aluminum snapped. I wish I could get a refund and my time back from installing this cheap crappy product. Do not recommend.

Very good, sturdy

Ich habe den Gepäckträger nun seit einigen Wochen im Einsatz und bin insgesamt sehr zufrieden. Die Verarbeitung wirkt hochwertig: Der Rahmen ist stabil, die Schweißnähte sind sauber verarbeitet, und das Material macht einen langlebigen Eindruck. Montage: Die Anleitung war klar verständlich, und die Montage verlief problemlos. Alle nötigen Schrauben und Halterungen waren im Lieferumfang enthalten. Auch an mein Fahrrad mit 28-Zoll-Rädern ließ sich der Träger gut anpassen. Praxistest: Im Alltag hat sich der Gepäckträger bewährt. Er trägt locker 15 kg ohne zu wackeln oder sich zu verbiegen. Die Federklappe hält kleinere Gegenstände gut fest, und für längere Touren nutze ich Satteltaschen – auch das klappt problemlos. Ein integrierter Rücklichthalter ist ebenfalls vorhanden, was ich sehr praktisch finde. Fazit: Ein zuverlässiger, robuster Gepäckträger zum fairen Preis. Ideal für Alltag, Einkäufe oder kleine Touren. Wer regelmäßig schwere Lasten transportiert, sollte jedoch darauf achten, die maximale Belastungsgrenze nicht zu überschreiten.

Fantastico. Molto robusto e sicuro per chi, come me, desidera installare il seggiolino per bimbi. Ben imballato. Consegna veloce. Montaggio impegnativo, ma abbastanza intuitivo. Nella confezione c'è anche una piccola brugola, ma sarebbe stata utile anche una chiave inglese, che serve. Inoltre, il foglietto delle istruzioni è veramente fatto male e sono in inglese: le figure non sono per niente nitide ed essendo a colori, non si ha un chiaro riferimento per il montaggio. Penso che per un buon prodotto così, si potrebbero fare delle istruzioni migliori, con figure in b/n e non su carta lucida....e, possibilmente, in multi lingue, almeno le principali. In conclusione, ottimo prodotto, molto soddisfatta e lo consiglio.

Prima bagagedrager. Goed te montern

I needed a rack that could handle more than just a light jacket or a lunch box, as I use my bike for heavy grocery runs and the occasional camping trip. Most standard racks top out around 25kg, so the 80kg rating on this one immediately caught my eye. I was a little worried about fitting it to my hybrid because the frame geometry is a bit weird, but the adjustability on the legs and the sliding seat rail mount made it surprisingly easy to get it level. Once everything was tightened down, this thing felt bombproof. I loaded up two full pannier bags yesterday—probably pushing 30-35kg total with liquids—and there was absolutely no side-to-side sway or rattling, even when I hit a few potholes. It feels much more substantial than the flimsy aluminum one I replaced. If you need a workhorse rack that doesn't cost a fortune, this is a solid bet.