motoparty Motorcycle Turn Signals For KAWASAKI EX250R NINJA 250R KLX250S KLX250SF VN650 Vulcan S Front/Rear Turn Signal Indicator Light Blinker Lamp Motorcycle, (Smoke Shell)

Wired up and bolted on easily to my 2011 ninja 250. I see people have blinking issues. If I’m stopped at a light sometimes I have to rev the bike a touch to give em the power to blink. But I got the bike minus the front signals so I can’t say if it’s these specific blinkers or an issue with my bike.

Broke a turn signal light on my daughter's 2009 Ninja 250R. Bought these to replace the broken light. Was able to install it without much difficulty. Works well. Would buy them again.

Great replacement for the OEM at a fraction of the cost. Build quality and fit is identical to OEM. It just as bright and functions perfectly. I recommend this item.

Easy to install plug n play 1 light didn't work but no biggie I bought 4 only needed 2 the only thing I was picky about was the silicone that was left around the housing it was kind of messy and stringy but a quick clean up on the light and it looked good make sure if your buying these lights you get led resisters or they won't blink on some bikes like kawasaki ninjas

First time they shipped to me, one was completely exploded in the package. I sent it back and got a replacement. Second time, I went to install them, and since they are made of such cheap plastic and not well made, the part that’s made to bend, completely snapped. Once again I sent them back and got another replacement. Third times the charm right? Wrong. These ones I installed, and all was well until I actually went to use them. They don’t flash at all, when you turn on either indicator, it just stays a solid orange which is super dangerous at night. I’m honestly pretty disappointed because these had decent reviews and are the only kind of its sort on Amazon. Only pros I can say is that they are super easy to install.

The female pin legs inside this turn signal harness are CLOSED so the male pins on the motorcycle side harness won't slide into the female pin legs on the turn signal harness. You need to take a precision pick and OPEN the female pin legs to allow the male pin to slide in. The harness was about 3 inches shorter than the OEM turn signal harness so getting it to connect was a bit of work, where the old harness had extra play to pull the snap harness UP and unplug it. The bulb provided did turn ON but would not blink. I had to remove that bulb and put in the OEM bulb, then it flashed as it should. Thankfully i am mechanically inclined so i was able to make it work, otherwise you would have to find someone to do what i did or replace this item. My issue was NOT the bulb, i actually dropped a 2x4 piece of wood and it hit the turn signal assembly and BROKE it off so i had to change out the hole piece. Then ran into the above problems but hey for $19 for a generic replica with these minor issues was better than $60 oem replacement.

Buy it,work great.

screws stripped one one side

Fits and work well

The installation is easy enough. The connection plug is delicate, be careful when plugging it in. The signal is a great and easy mod.

Great product

Embono perfectamente es idéntico al original solo pues cambia la calidad de los materiales, en mi casa los compre para reemplazar solo la parte transparente y quedo igual que original