Universal Vynal Forklift Seat

They are exactly as pictured and described.....they are basically two upholstered pads screwed into a sheet-metal shell.... The slide tracks can be removed to mount the seats on a flat surface, if preferred.... The bottom pad is a bit thicker than pictured and they are comfortable..... I used them in an early van and like that they are lightweight and just big enough..... I liked them better at $90 than $115, but, oh well!

I actually like it better than the original. Way cheaper too

i got 1 before for my Forklift its very good

This appears to be good quality for an inexpensive seat. I mounted it on my Lion Liftall forklift with a little modification. I had modified my seat base once before for the last seat that I had installed on it by welding a couple pieces of angle iron to it to make it wider. To mount this seat, I just had to drill new holes in the angle iron to fit the new bolt pattern. There are four 5/16" studs on the bottom of the seat set at 11" front to back and 10 3/4" side to side. The seat came with washers, lock washers and nuts for each of the studs. It has hardware on it to allow the seat position to be moved front to back several inches. It's very comfortable and the vinyl is flexible and appears to be good quality. It should last for at least a few years without cracking and tearing.

The media could not be loaded.

Great product for the cost. I was concerned about the quality and set up but it fit right into the Toyota forklift I was repairing. Was actually an exact fit. Seems actually of pretty good quality especially the thickness of the bottom foam. Definitely buying again for my next forklift buildHole mounting was 11" front to back and 10 3/4 side to side. However if your application does meet that but can be drilled, you could always do that

The seller ignore my question about hole spacing. There were some answers to my question but I don't know what the hole spacing is.I took a chance and bought it. I was able to mount it to my Toyota fork lift by drilling new holes. Luckily I was able to position the holes to avoid some stuff in the engine.For whoever is thinking about it. It does come with frame and the hole spacing is 10-3/4" side to side and 11" front to rear.Let's see if this seat holds up to years of use.

4 bolts and it was installed in no time at all. The adjustment is smooth and easy to use