🚀 Elevate Your Racing Game!
The T-Motor F55A PROII ESC is a high-performance 4-in-1 electronic speed controller designed for racing drones. It features a robust 32-bit control chip, supports up to 55A current, and incorporates advanced cooling and damping designs to ensure optimal performance and longevity.
P**S
Very happy with the performance on my 10 inch build
Paired this with 4 Brother Hobby 3115 900kv motors which I expected to draw 160-200 amps at full throttle on 6S. So far it's working and flying great, though lots of fine tuning to do. Haven't verified power draw at full throttle, but no issues so far. The XT60 connector felt undersized considering this could have 200+ amps going through at once. I personally opted for the XT90 connector to be on the safe side.I'm still somewhat new to this hobby and wanted to build something bigger. My soldering skills have had to make the biggest jump and I've been impressed that this could take the heat-punishment that I dealt it when I was using too small a tip. If you don't tin your wires you'll want to, working with something this size.
S**H
Blow too easily
These are my Least fav esc… they can’t handle a crash or fly in high temps. Get the velox instead
J**Y
Great I love it
Love it but I wouldn't put race props to it. Not saying it wouldn't be good or won't work but if you been in this hobby for a min then you should know what could happen
M**L
Don't buy 4 in 1 esc's
ok I bought this $ in one Esc thinking it would be better and top quality with all the hype on youtube but it lasted 2 flights before only one motor worked done with 4 in one ESC's what a waste of money
J**D
Used
Used
Y**A
Bad line of ESCs, terrible company support
The Pro I line of this exact ESC was a complete piece of trash, I bought five of them from GetFPV and three of them failed immediately. They are not rated for 6S, I literally smoked a brand new 2750kv TOA motor - as in, sparks and smoke and my Chameleon falling like a rock two feet in front of me - both ESCs died in the same fashion, dead #2 ESC in both after just a few flights each. Then the third ESC the circuit board backing fell off, no adhesive with the companion daughterboard and it heated up to the point of melting the solder joints that were holding it on.So then T-Motor pulls then entire Pro I line during all of this, I processed an RMA with GetFPV and agreed to hang on to them so swap them out for the Pro II line. Later after the Pro II line is released, T-Motor wouldn't honor any replacement citing to warranty even though I had documented via GetFPV RMA all three failed ESCs within a month after purchasing them.Nonexistent company support, badly engineered product, use something else.
Trustpilot
1 month ago
2 months ago